docs: sync command reference; drop iq_bursts.py superseded by verify_repeats_iq.py
This commit is contained in:
@@ -16,6 +16,7 @@ This is **not** a standards-compliant repeater. See
|
||||
```
|
||||
firmware/ ESP-IDF app: SX1262 GFSK driver, wM-Bus C1 RX/TX,
|
||||
repeater state machine, recovery ladder, JSON telemetry
|
||||
firmware/test/ host-side frame-layer tests (run under AddressSanitizer)
|
||||
hil/ hardware-in-the-loop harness (run.sh is the entry point)
|
||||
tools/ device discovery, flashing, reset
|
||||
docs/ hardware evidence, RF config, findings, timing, gaps
|
||||
@@ -37,11 +38,7 @@ Serial console (scriptable, JSON output):
|
||||
|
||||
```bash
|
||||
./result-py/bin/python3 hil/dut_cmd.py <port> --listen 5 status stats
|
||||
# status | stats | clear_stats | radio_status | radio_reset | probe
|
||||
# test_tx | test_burst | reboot
|
||||
# set repeat_delay_ms N | set tx_power N | set repeat_enabled 0|1
|
||||
# set verbose 0|1 | set fem_rx_csd 0|1 | set pa_low 0|1
|
||||
# set test_lfield N | set whitelist ID[,ID...] | set whitelist clear
|
||||
# full command list: docs/TESTING.md
|
||||
```
|
||||
|
||||
## Results (measured, not inferred)
|
||||
|
||||
Reference in New Issue
Block a user