docs: withdraw degraded-observer match rate, record observer drift and IQ TX proof
This commit is contained in:
+26
-8
@@ -52,18 +52,36 @@
|
||||
|
||||
## CONFIRMED (measurement methodology)
|
||||
|
||||
- Heltec RX is competitive with the Nooelec observer on identical traffic:
|
||||
124 of 127 SDR-classified originals matched byte-exactly in a 30 min run
|
||||
(97 % across 32 meters).
|
||||
- WITHDRAWN: an earlier entry claimed "Heltec matched 124 of 127 SDR
|
||||
originals (97 %)". That measurement was taken while the dongle was in its
|
||||
degraded state, so the SDR decoded few originals and the Heltec matched
|
||||
nearly all of them. With the observer state recorded, the honest figure is
|
||||
58.5 % of SDR originals matched (600 s run, observer "degraded"), with
|
||||
each receiver also decoding meters the other missed. See
|
||||
docs/RF_FRONTEND_TESTS.md.
|
||||
- Repeat payloads are byte-exact: 63/63 logged `tx_payload` values equalled
|
||||
mode bytes + the received raw frame. No corruption in the RX->TX path.
|
||||
- Our repeats DO radiate. IQ capture shows burst pairs at 54-55 ms spacing
|
||||
with 9-10 ms duration (matches 100 kbps x ~100 bytes) - the repeat is
|
||||
real RF, independently observed, even when rtl-wmbus cannot decode it.
|
||||
- The observer, not the repeater, limits repeat decoding: our TX arrives
|
||||
~36 dB stronger than meter traffic and sits at RTL-SDR full scale.
|
||||
- Real repeats are emitted as correct RF: aligning firmware TX timestamps
|
||||
to bursts in the same stream's IQ confirmed 48 of 57 TX events (84 %),
|
||||
with alignment error median 1.3 ms (max 3.6 ms) and burst duration within
|
||||
0.5 ms (median) of the computed airtime. Firmware repeat delay measured
|
||||
200.0 ms min/median/max against a 200 ms setting.
|
||||
- Firmware TX reliability over 600 s: tx_attempts 58, tx_success 58,
|
||||
tx_timeout 0, tx_failures 0, recoveries 0.
|
||||
- The observer, not the repeater, limits repeat DECODING. In the dongle's
|
||||
full-sensitivity state our TX arrives ~36 dB stronger than meter traffic
|
||||
and reaches RTL-SDR full scale; rtl-wmbus then receives our repeat with
|
||||
1-2 byte errors and fails CRC (observed directly: transmitted
|
||||
`...78534f4c5458...` decoded as `...78514f4c5448...`, rest bit-exact).
|
||||
Raising the repeat delay 50 -> 200 ms improved SDR repeat decoding from
|
||||
3 % to 30 % (demodulator level-estimate recovery).
|
||||
- The dongle's sensitivity drifts ~17 dB within minutes of streaming, so
|
||||
captures taken at "the same gain" at different times are NOT comparable.
|
||||
Meter decodes and our own TX measurements must come from one stream
|
||||
(`hil/capture_both.sh`).
|
||||
- `rtl_sdr -g 0` selects AUTOMATIC gain, not 0 dB; lowest real fixed gain
|
||||
is 0.9 dB. Low fixed gain is not a usable workaround while degraded:
|
||||
at 0.9 and 7.7 dB nothing decoded at all.
|
||||
- Synthetic C1 bursts from the Heltec (L = 19/40/60/98) are decoded by
|
||||
rtl-wmbus as valid C1 with correct CRCs, including two airings of the
|
||||
same frame 50/100/200 ms apart. TX framing is therefore correct and
|
||||
|
||||
Reference in New Issue
Block a user