# Findings ## CONFIRMED - Heltec V4.3 SX1262 pin mapping (NSS 8, SCK 9, MOSI 10, MISO 11, RST 12, BUSY 13, DIO1 14): SPI write/readback passes, radio enters RX (`radio_init: spi:true, reset:true, tcxo:true, result:ok`). - TCXO is DIO3-controlled at 1.8 V; without post-TCXO recalibration the XOSC_START_ERR device error appears. With recalibrate: no device errors. - KCT8103L FEM on GPIO7 (power), GPIO2 (CSD), GPIO5 (CTX), CPS on DIO2. RX works with CSD high + CTX low + DIO2-as-RF-switch. - Firmware heartbeat RSSI in RX: -101..-107 dBm noise floor -> RX chain with boosted gain is plausibly alive. - Nooelec NESDR SMArt v5 R820T PLL wedges ("PLL not locked"), producing gain-independent white noise on all frequencies until USB reset. `usbreset 0bda:2838` reliably restores operation. Trigger correlated with `rtl_test -t` direct-sampling probe. - rtl-sdr-blog and osmocom rtl_sdr builds behave identically w.r.t. the wedge; not a driver-fork issue. - Real C1 traffic exists at this site (first telegram decoded 22:23 local, meter ID 04767752). ## LIKELY - Fixed 255-byte RX capture adds up to ~20 ms artificial dead time per frame (by construction; to be measured). ## DISPROVEN - "rtl_sdr pipeline works out of the box": the PLL wedge cost ~20 minutes of empty captures. Always energy-probe the SDR before trusting a null result. ## NEEDS TESTING - Heltec C1 RX of real meter frames (SDR sees traffic; Heltec match TBD). - TX proof of life via SDR. - LNA on/off comparison (KCT8103L CSD low in RX = bypass?). - Repeat delay accuracy, RX deaf time distribution. - Long-run stability (>=100, >=500 repeats).