firmware: SX1262 GFSK wM-Bus C1 repeater, dev tooling, discovery scripts
This commit is contained in:
@@ -0,0 +1,36 @@
|
||||
// Heltec WiFi LoRa 32 V4.3 (HTIT-WB32LAF) board definition.
|
||||
//
|
||||
// Sources:
|
||||
// - Heltec wiki "WiFi LoRa 32 V4" product page (USE_KCT8103L_PA for V4.3)
|
||||
// - Heltec schematic HTIT-WB32LAF_V4.3.pdf
|
||||
// - RNode_Firmware 1.86 / RTNode-HeltecV4 Boards.h + sx126x.cpp
|
||||
// (experimentally proven working configuration for this exact board)
|
||||
//
|
||||
// See docs/HARDWARE.md for the full evidence trail.
|
||||
#pragma once
|
||||
|
||||
// SX1262 SPI + control
|
||||
#define BOARD_LORA_NSS 8
|
||||
#define BOARD_LORA_SCK 9
|
||||
#define BOARD_LORA_MOSI 10
|
||||
#define BOARD_LORA_MISO 11
|
||||
#define BOARD_LORA_RESET 12
|
||||
#define BOARD_LORA_BUSY 13
|
||||
#define BOARD_LORA_DIO1 14
|
||||
|
||||
// KCT8103L RF front-end (V4.3)
|
||||
// PWR_EN : FEM supply enable, drive HIGH
|
||||
// CSD : chip enable, drive HIGH (has internal pull-up on KCT8103L,
|
||||
// which is how RNode 1.86 auto-detects V4.3 vs V4.2/GC1109)
|
||||
// CTX : path select, LOW = RX/LNA, HIGH = TX/PA
|
||||
// CPS : wired to SX1262 DIO2 (DIO2-as-RF-switch must be enabled)
|
||||
#define BOARD_FEM_PWR_EN 7
|
||||
#define BOARD_FEM_CSD 2
|
||||
#define BOARD_FEM_CTX 5
|
||||
|
||||
// SX1262 TCXO: DIO3-controlled, 1.8 V (RNode 1.86 value for this board)
|
||||
#define BOARD_TCXO_VOLTAGE_CODE 0x02 // MODE_TCXO_1_8V
|
||||
#define BOARD_TCXO_DELAY_STEPS 0xFF // x 15.625 us ~= 4 ms
|
||||
|
||||
// Overcurrent protection value from RNode 1.86 ("OCP_TUNED 0x28")
|
||||
#define BOARD_SX1262_OCP 0x28
|
||||
Reference in New Issue
Block a user