findings: weak USB supply kills radiated TX while TxDone still fires; A/B laptop vs wall adapter
This commit is contained in:
@@ -146,3 +146,20 @@
|
||||
- Narrower RX bandwidth (156 kHz) vs current 234.3 kHz on weak meters.
|
||||
- Long-run stability at >=100 and >=500 verified repeat events.
|
||||
- Early-stop RX (poll GetRxBufferStatus) to cut the ~20 ms deaf tail.
|
||||
|
||||
## CONFIRMED (power supply, field debugging 2026-09-01)
|
||||
|
||||
- A weak USB supply silently kills radiated TX while everything else looks
|
||||
healthy: SX1262 reaches TxDone, firmware counts success, LED double-blinks
|
||||
-- but the SDR 50 cm away sees nothing. A/B proof: laptop USB 7/7 TX
|
||||
events RF-aligned (median +37 dB over floor); wall adapter minutes later,
|
||||
same position: 0 of ~expected 5-7 across 80 s (and 0 across four earlier
|
||||
captures). Suspected mechanism: rail sag during the KCT8103L PA burst.
|
||||
"TX done" is chip-level packet completion, not radiated power.
|
||||
- Practical rule: power the repeater from a supply that holds 5 V through
|
||||
~400 mA bursts (laptop port, 2 A charger, power-bank USB-A, or LiPo).
|
||||
After any supply change, verify with one 60 s SDR capture -- the LED
|
||||
cannot distinguish radiating from non-radiating TX.
|
||||
- The recurring 10-24 ms bursts at +30..+43 dB ("monster singletons") are a
|
||||
neighbouring meter railing the dongle, NOT the repeater: their rate is
|
||||
unchanged across our firmware versions, reboots, and power sources.
|
||||
|
||||
Reference in New Issue
Block a user