Files
heltec-repeater/docs/devboard_signals.csv
T

22 lines
1.9 KiB
CSV

signal,device,gpio,direction,voltage,interrupt,timing_critical,test_point_required,header_required,reason
WMBUS_NSS,SX1262,8,output,3.3,false,true,true,true,SPI decode of radio commands during bring-up
WMBUS_SCK,SX1262,9,output,3.3,false,true,true,true,SPI decode
WMBUS_MOSI,SX1262,10,output,3.3,false,true,true,true,SPI decode
WMBUS_MISO,SX1262,11,input,3.3,false,true,true,true,SPI decode
WMBUS_RESET,SX1262,12,output,3.3,false,false,true,true,radio recovery verification
WMBUS_BUSY,SX1262,13,input,3.3,false,true,true,true,command-timing and stuck-BUSY debugging
WMBUS_DIO1,SX1262,14,input,3.3,true,true,true,true,RX/TX IRQ latency measurement
FEM_PWR_EN,KCT8103L,7,output,3.3,false,false,true,true,FEM power sequencing verification
FEM_CSD,KCT8103L,2,output,3.3,false,false,true,true,FEM enable + board-revision detection (pull level)
FEM_CTX,KCT8103L,5,output,3.3,false,true,true,true,RX/TX path switch timing vs TX start
ESP_USB_DN,ESP32-S3,19,bidir,3.3,false,false,false,true,flash/console; must stay accessible
ESP_USB_DP,ESP32-S3,20,bidir,3.3,false,false,false,true,flash/console
RADIO_VDD_SENSE,SX1262,,analog,3.3,false,true,true,false,current sense to confirm PA activity during TX
LOG_UART_TX,ESP32-S3,43,output,3.3,false,false,true,true,always-on boot/log output independent of native USB
RF_TAP,antenna,,rf,,false,false,true,false,conducted measurement port with fixed attenuator to avoid observer overload
OLED_SDA,SSD1306,17,bidir,3.3,false,false,true,true,local status UI; must not share a bus with RF-critical peripherals
OLED_SCL,SSD1306,18,output,3.3,false,false,true,true,local status UI
OLED_RST,SSD1306,21,output,3.3,false,false,true,false,display enable/reset; LOW then HIGH with 50ms settle
VEXT_EN,board,36,output,3.3,false,false,true,false,active-low external rail powering the display; verify what else it gates
BTN_USR,ESP32-S3,0,input,3.3,true,false,true,true,user button; also BOOT strap so unusable for boot-time gestures