31 lines
1.5 KiB
Markdown
31 lines
1.5 KiB
Markdown
# Future Solenos/Gebos dev-board requirements
|
|
|
|
Derived from actual debugging needs during this experiment. Machine-readable
|
|
pin list: devboard_signals.csv.
|
|
|
|
## Debug access that proved necessary
|
|
|
|
- SX1262 BUSY + DIO1 on test points: needed to reason about command timing,
|
|
IRQ latency, and stuck-BUSY recovery without guessing.
|
|
"I needed direct access to this signal because the only alternative was
|
|
inferring radio state from SPI responses."
|
|
- Full SPI bus (NSS/SCK/MOSI/MISO) on a header: logic-analyzer decode of
|
|
the SX1262 command stream is the ground truth when firmware and radio
|
|
disagree.
|
|
- FEM control lines (PWR_EN, CSD, CTX): RX sensitivity and TX output both
|
|
silently break if these are wrong; scoping them is the fastest check.
|
|
CSD doubles as board-revision detect (pull level) — keep it probeable.
|
|
- Native USB pins must remain dedicated to flash/console; the DUT USB
|
|
identity changes between app and ROM bootloader, so the dev board should
|
|
also expose UART0 TX as an always-on log output (the Heltec does not,
|
|
which made early-boot debugging blind).
|
|
|
|
## Wishlist beyond the current board
|
|
|
|
- Always-available secondary UART for logs (independent of native USB).
|
|
- Measurable radio power rail (current shunt) to correlate TX events with
|
|
actual PA draw — would have settled "is the FEM PA active?" instantly.
|
|
- RF test connector (u.FL tap or directional coupler) for conducted
|
|
measurements instead of over-the-air-only verification.
|
|
- ESP32 BOOT/RESET buttons brought to a header for automated strapping.
|