Files
heltec-repeater/docs/FINDINGS.md
T

1.6 KiB

Findings

CONFIRMED

  • Heltec V4.3 SX1262 pin mapping (NSS 8, SCK 9, MOSI 10, MISO 11, RST 12, BUSY 13, DIO1 14): SPI write/readback passes, radio enters RX (radio_init: spi:true, reset:true, tcxo:true, result:ok).
  • TCXO is DIO3-controlled at 1.8 V; without post-TCXO recalibration the XOSC_START_ERR device error appears. With recalibrate: no device errors.
  • KCT8103L FEM on GPIO7 (power), GPIO2 (CSD), GPIO5 (CTX), CPS on DIO2. RX works with CSD high + CTX low + DIO2-as-RF-switch.
  • Firmware heartbeat RSSI in RX: -101..-107 dBm noise floor -> RX chain with boosted gain is plausibly alive.
  • Nooelec NESDR SMArt v5 R820T PLL wedges ("PLL not locked"), producing gain-independent white noise on all frequencies until USB reset. usbreset 0bda:2838 reliably restores operation. Trigger correlated with rtl_test -t direct-sampling probe.
  • rtl-sdr-blog and osmocom rtl_sdr builds behave identically w.r.t. the wedge; not a driver-fork issue.
  • Real C1 traffic exists at this site (first telegram decoded 22:23 local, meter ID 04767752).

LIKELY

  • Fixed 255-byte RX capture adds up to ~20 ms artificial dead time per frame (by construction; to be measured).

DISPROVEN

  • "rtl_sdr pipeline works out of the box": the PLL wedge cost ~20 minutes of empty captures. Always energy-probe the SDR before trusting a null result.

NEEDS TESTING

  • Heltec C1 RX of real meter frames (SDR sees traffic; Heltec match TBD).
  • TX proof of life via SDR.
  • LNA on/off comparison (KCT8103L CSD low in RX = bypass?).
  • Repeat delay accuracy, RX deaf time distribution.
  • Long-run stability (>=100, >=500 repeats).