41 lines
1.6 KiB
Markdown
41 lines
1.6 KiB
Markdown
# Findings
|
|
|
|
## CONFIRMED
|
|
|
|
- Heltec V4.3 SX1262 pin mapping (NSS 8, SCK 9, MOSI 10, MISO 11, RST 12,
|
|
BUSY 13, DIO1 14): SPI write/readback passes, radio enters RX
|
|
(`radio_init: spi:true, reset:true, tcxo:true, result:ok`).
|
|
- TCXO is DIO3-controlled at 1.8 V; without post-TCXO recalibration the
|
|
XOSC_START_ERR device error appears. With recalibrate: no device errors.
|
|
- KCT8103L FEM on GPIO7 (power), GPIO2 (CSD), GPIO5 (CTX), CPS on DIO2.
|
|
RX works with CSD high + CTX low + DIO2-as-RF-switch.
|
|
- Firmware heartbeat RSSI in RX: -101..-107 dBm noise floor -> RX chain
|
|
with boosted gain is plausibly alive.
|
|
- Nooelec NESDR SMArt v5 R820T PLL wedges ("PLL not locked"), producing
|
|
gain-independent white noise on all frequencies until USB reset.
|
|
`usbreset 0bda:2838` reliably restores operation. Trigger correlated
|
|
with `rtl_test -t` direct-sampling probe.
|
|
- rtl-sdr-blog and osmocom rtl_sdr builds behave identically w.r.t. the
|
|
wedge; not a driver-fork issue.
|
|
- Real C1 traffic exists at this site (first telegram decoded 22:23 local,
|
|
meter ID 04767752).
|
|
|
|
## LIKELY
|
|
|
|
- Fixed 255-byte RX capture adds up to ~20 ms artificial dead time per
|
|
frame (by construction; to be measured).
|
|
|
|
## DISPROVEN
|
|
|
|
- "rtl_sdr pipeline works out of the box": the PLL wedge cost ~20 minutes
|
|
of empty captures. Always energy-probe the SDR before trusting a null
|
|
result.
|
|
|
|
## NEEDS TESTING
|
|
|
|
- Heltec C1 RX of real meter frames (SDR sees traffic; Heltec match TBD).
|
|
- TX proof of life via SDR.
|
|
- LNA on/off comparison (KCT8103L CSD low in RX = bypass?).
|
|
- Repeat delay accuracy, RX deaf time distribution.
|
|
- Long-run stability (>=100, >=500 repeats).
|